If you want to improve your grades and boost your confidence before your CCNA exams, try SPOTO‘s CCNA® test dumps based on the latest test guideline,as well as to get a sense for the exam structure. Improve your speed and time management on the CCNA® exam by practicing the ten sample questions listed below.

get 100% pass dumps

Question 1:

 What is the maximum cable length for UTP Ethernet T implementations?

Correct answer: C

 

Question 2:

 Which of the following commands can be used to enable IPv6 routing on Cisco equipment?

Correct answer: B

 

Question 3

Terry is using the EIGRP routing protocol. Terry wants to use a single route to represent multiple routes to reduce the size of routing tables in the network. Which of the following routing summarization methods is being used?

Correct answer: D

 

Question 4

RTR1, RTR2, and RTR3 have been configured to use the OSPF protocol. RTR1 and RTR2 are neighbors; RTR3 and RTR2 are also neighbors.
RTR2 fails to receive a hello packet from RTR3 within the dead interval. Which of the following happens next?

Correct answer: B

get 100% pass dumps

Question 5

 Your network uses a network address of 137.65.0.0 with a subnet mask of 255.255.0.0. How many IP addresses are available for assignment to network hosts on this network?

Correct answer: A

 

Question 6:

While working at the console of a Cisco device, you need to view a list of the commands that are available in the current mode. Which command should you use?

Correct answer:C

 

Question 7:

Which of the following is a good general rule regarding the placement of extended ACLs?

Correct answer: D

 

Question 8:

Which command uses the correct syntax and argument to create an IPv6 ACL?

Correct answer: C

 

Question 9:

You need to place a wireless access point in your two-story building. While trying to avoid interference, which of the following is the best location for the access point?

Correct answer: C

 

Question 10:

You need to connect a router to a subnet. The subnet uses the IP address 192.168.12.0/26. You are instructed to assign the last IP address on the subnet to the router. Which IP address will you use?

Correct answer:G

 

Conclusion

The preparation process for the forthcoming CCNA Exam in 2022 might not be easy, especially when there is a lot to learn in a short amount of time. SPOTO‘s CCNA® test dumps and training courses are the most effective approach to prepare for and track your progress toward the CCNA® certification.

get 100% pass dumps

Latest SPOTO Candidates Pass Feedback

Last modified: 2022-03-07

Author

Comments

Write a Reply or Comment

Your email address will not be published.