Our high-quality professional CCNA exam preps have been used by hundreds of thousands. SPOTO dumps will make you a certified professional on your exam day!
Question 1
What are two recommendations for protecting network ports from being exploited when located in an office space outside of an IT closet? (Choose two)
A. configure static ARP entriescorrect
B. enable the PortFast feature on ports
C. implement port-based authenticationcorrect
D. configure ports to a fixed speed
E. shut down unused ports
Correct answer: ACE
Question 2
What is a practice that protects a network from VLAN hopping attacks?
A. Enable dynamic ARP inspection
B. Configure an ACL to prevent traffic from changing VLANs
C. Change native VLAN to an unused VLAN ID
D. Implement port security on internet-facing VLANs
Correct answer: C
Question 3
Which two statements about NTP operations are true? (Choose two.)
A. NTP uses UDP over I
B. Cisco routers can act as both NTP authoritative servers and NTP clients.
C. Cisco routers can act only as NTP servers.
D. Cisco routers can act only as NTP clients.
E. NTP uses TCP over I
Correct answer: A
Question 4
Which command must you enter to guarantee that an HSRP router with higher priority becomes the HSRP primary router after it is reloaded?
A. standby 10 preemptcorrect
B. standby 10 version 1
C. standby 10 priority 150
D. standby 10 version 2
Correct answer: A
Question 5
Which IPv6 address block forwards packets to a multicast address rather than a unicast address?
A. 2000::/3
B. FC00::/7
C. FE80::/10
D. FF00::/12
Correct answer: D
Question 6
How do servers connect to the network in a virtual environment?
A. wireless to an access point that is physically connected to the network
B. a cable connected to a physical switch on the network
C. a virtual switch that links to an access point that is physically connected to the network
D. a software switch on a hypervisor that is physically connected to the network
Correct answer: D
Question 7
Which command should you enter to view the error log in an EIGRP for IPv6 environment?
A. show ipv6 eigrp neighbors
B. show ipv6 eigrp topology
C. show ipv6 eigrp traffic
D. show ipv6 eigrp events
Correct answer: D
Question 8
What is the effect when loopback interfaces and the configured router ID are absent during the OSPF Process configuration?
A. No router ID is set, and the OSPF protocol does not run.
B. The highest up/up physical interface IP address is selected as the router I
C. The lowest IP address is incremented by 1 and selected as the router I
D. The router ID 0.0.0.0 is selected and placed in the OSPF process.
Correct answer: B
Question 9
Which two protocols must be disabled to increase security for management connections to a Wireless LAN Controller? (Choose two)
A. Telnet
B. SSH
C. HTTP
D. HTTPS
E. TFTP
Correct answer: AC
Question 10
Which protocol is used for secure remote CLI access?
A. HTTPS
B. HTTP
C. Telnet
D. SSH
Correct answer: D
You will have the ability to: Describe the fundamentals of networks and set up virtual local area networks (LANs); Perform routing operations and configure routing protocols; Manage the security of network devices; Expand small to medium-sized networks with internet access; Fundamentals of IPv4 and IPv6. Please get in touch with SPOTO as soon as possible if you are serious about passing the examination on the very first attempt.
Comments